دتکتور گاز ضد انفجار برند Drager مدل Polytron 5310

(Drager Brand Explosion-proof Model Polytron 5310)

Drager Brand Explosion-proof Model Polytron 5310

Description

Quick, reliable and cost-effective detection of combustible gases and vapors in ambient air: the microprocessor-based Dräger Polytron® ۵۳۱۰ transmitter is the result of more than 40 years of experience in measurement technology and contains a durable, poison-resistant IR sensor.

Benefits

Proven – and still getting better: Dräger measurement technology

Dräger has been developing and manufacturing sensors and gas detectors for industrial use for more than 40 years.

And with each new device generation, we drive our measurement technology a bit further.

With the Polytron 5310, you will definitely benefit from this experience and power of innovation:

‒ durable sensors

‒ short response times

‒ high sensitivity

‒ high accuracy

‒ low sensitivity to changing ambientconditions

Optional: three relays for controlling external equipment

Upon request, the Dräger Polytron 5310 can be supplied with three integrated relays.

This enables you to use it as an independent gas detection system with two arbitrarily adjustable concentration alarms and one fault alarm.

Audio alarms, signal lights, or similar devices can, thus, be controlled locally – without an additional cable between the transmitter and a central controller.

The sensor signal can be evaluated using the 4 to 20 mA signal.

Optional: two mounting sets for easy flange-mounting

The housing has four mounting holes.

Two different mounting sets are available for installing the Polytron 5310: a duct-mount and a pipe mount set.

This means that the transmitter can be easily installed anywhere – e.g., on a smooth wall, a pipe or an exhaust duct.

Quick and easy wiring

The electronics and the bezel form a single unit.

Simply pull them out of the housing.

Then insert the three-wire cable into the terminals – either through the Ex-e cable gland or through the seal on the conduit.

Finally, plug the terminal block into the PCB.

Easy and cost-effective: single-operator calibration

The transmitter settings can be changed and maintenance carried out without opening the housing.

Declassification of the hazardous, classified area is not necessary.

Use the magnetic wand to quickly and easily select menu items and functions. Anadditional hand held terminal is not required.

Further advantages:

‒ Available as flameproof or increased safety version

‒ Aluminum or 316 L stainless steel housing for the most extreme industrial conditions

‒ Extremely user-friendly software thanks to a minimum number of menu items

‒ Backlit display: easy to read, even in the dark and without a flashlight

‒ Traffic light status indicator (green = no danger, yellow = error, flashing red = gas alarm)

*) order respective Sensing Head DSIR Remote ‘e’ Version and e-Box 68 12 275 separately

**) order e-Box 68 12 420 for power only wires separately

***) order e-Box 68 12 275 for power and/or relay wires separately